不同降雨入渗条件下预应力锚索加固边坡稳定性分析

为了研究不同降雨条件下边坡安全系数及预应力锚索轴力变化规律,以省道S303沿线某边坡为研究对象,考虑土体饱和-非饱和渗流与非饱和强度理论,基于有限元分析,对不同降雨工况下的孔隙水压分布、锚索轴力及采用强度折减法计算的边坡安全系数变化规律进行了研究。结果表明: 降雨量一定时,降雨入渗范围随雨强增大而减小,暂态饱和区域随雨强增加而增大; 边坡在加固前后的安全系数均随降雨量增加而不断减小,采用预应力锚索加固能有效提高边坡安全系数,并减小降雨对边坡稳定性的影响; 随着降雨量增加,各锚索轴力均增大,当降雨量一定时,雨强越小,对应的锚索轴力提升幅度越大,靠近底部的锚索轴力对降雨最为敏感。     

Physicochemical and technological properties of beef burger as influenced by the addition of pea fibre

This study aimed to evaluate the physicochemical characteristics and sensory attributes of beef burgers with the addition of pea fibre as a partial substitute of meat or fat. Three formulations were prepared: control (CON) – similar to the commercial formulation; fibre/less meat (FLM)—5% meat reduction and addition of 1% pea fibre; fibre/less fat (FLF)—7% fat reduction and addition of 1% pea fibre. Non-significant differences were obtained for pH, colour parameters (L* and b*), texture profile, cooking loss and size reduction among formulations. Moreover, sensory analysis with consumers of beef burgers did not indicate differences among the formulations for all the analysed attributes. Therefore, pea fibre is a promising partial replacer for meat and fat in beef burgers due to the preservation of technological parameters and sensory acceptance.     

煤磨热风管道改造的效果

中联万基水泥有限公司4500t/d熟料生产线采用SCLW4-12×13.4第四代篦冷机,煤磨热风取风口和余热发电AQC热风取风口在篦冷机同一对称位置,煤磨与余热发电系统存在争风现象,开停煤磨对余热发电系统影响较大。通过从废气管道处开孔,加装管道和电动阀,与热风管道汇合通往煤磨沉降室,调整相应阀门开度,可以控制入煤磨烟气温度,这样不但提高了余热发电量,而且提高了煤磨产量,同时也降低了窑头排风机的负荷,降低了熟料生产电耗。     

高频氢等离子体增强还原制备超细铜粉

利用高频感应热氢等离子体强化还原制备超细铜粉，考察了加料速率、还原氢气流量、氢气分布位置、反应区空间、冷却温度等因素对铜粉颗粒性能的影响，对制备的铜粉颗粒进行氧含量、XRD晶体结构、松装密度、粒度分布和比表面积的表征。结果表明，优化的工艺条件为反应区内径100 mm，加料速率4 g/min，淬火气氩气气量500 L/h，氢气气量500 L/h并通入少量载气，由氢等离子电离产生的氢自由基可强化反应实现瞬时还原，不仅可控制铜粉形貌，还能有效控制铜粉颗粒大小；利用该方法制备出粒径分布100?200 nm、分散性好的超细球形铜粉颗粒。该方法操作简便、产品纯度高、气氛可控、对环境污染小。     

生物滴滤床法降解二氯甲烷废气的因素影响特征

二氯甲烷作为溶剂广泛应用于制药行业，其挥发性废气对人类健康和大气环境的危害极大。本文采用生物滴滤床对某制药厂浓度范围在0.02~2g/m³的二氯甲烷废气进行了为期132天的中试规模实验。在适宜的停留时间、温度、喷淋量和pH等实验条件下，控制适当的进气浓度可得到高效去除效率并且废气出口浓度达标。实验揭示了生物膜内生物降解是过程的限制因素，结果表明，在喷淋量为1200L/h、进气浓度范围为0.45~0.65g/m³时该生物系统去除效率最高可达98.9%，最大去除负荷可达EC_max=155.25g/(m³·h)。随着进气浓度的增加，去除负荷随之增大，而去除效率下降，废气出口浓度超标，表明生物滴滤系统已处于反应控制。此外，间歇实验表明，该生物系统具有良好的稳定性。指出生物滴滤床的设计、运行取决于当地的二氯甲烷废气排放标准。     

Deposition of nanostructured LSM perovskite thin film on dense YSZ substrate by airbrushed solution combustion (ASC) for application in SOFC cathodes

To make SOFC high efficiency energy generation devices, thin ceramic films are proposed as their main components. The rate of the oxygen reduction reaction is relevant for the overall performance of the SOFC, hence a lot of attention is given to the cathodes and their interfaces. The airbrushed solution combustion (ASC) method was used to fabricate an LSM thin film on a dense YSZ substrate. A single phase LSM perovskite was obtained with very thin and interconnected porosity, and a small average grain size (55 nm). The nanostructured LSM thin film electrode showed a low total activation energy (1.27 eV) at high temperatures, but a high area specific resistance at 850°C (55 Ω.cm²). The activation energy for the dissociative adsorption and diffusion of oxygen was significantly low (1.27 eV), while the charge transfer and oxygen ion migration activation energy at the LSM/YSZ interface (1.28 eV) was closer to those usually reported.     

铣削加工每齿进给量的决定因素研究及验证

研究了面铣刀的主偏角对切屑厚度和每齿进给量的影响,铣削中每齿进给量的决定因素,切削宽度与刀具直径的比值对切屑厚度的影响等问题进行理论分析,同时结合变速箱壳体铣削加工过程进行验证,解决了合理选择铣刀及切削参数以提升加工效率的问题。     

Performance analysis and temperature gradient of solid oxide fuel cell stacks operated with bio-oil sorption-enhanced steam reforming

A high temperature gradient within a solid oxide fuel cell (SOFC) stack is considered a major challenge in SOFC operations. This study investigates the effects of the key parameters on SOFC system efficiency and temperature gradient within a SOFC stack. A 40-cell SOFC stack integrated with a bio-oil sorption-enhanced steam reformer is simulated using MATLAB and DETCHEM. When the air-to-fuel ratio and steam-to-fuel ratio increase, the stack average temperature and temperature gradient decrease. However, a decrease in the stack temperature steadily reduces the system efficiency owing to the tradeoff between the stack performance and thermal balance between heat recovered and consumed by the system. With an increase in the bio-oil flow rate, the system efficiency decreases because of the lower resident time for the electrochemical reaction. This is not, however, beneficial to the maximum temperature gradient. To minimize the temperature gradient of the SOFC stack, a decrease in the bio-oil flow rate is the most effective way. The maximum temperature gradient can be reduced to 14.6 K cm⁻¹ with the stack and system efficiency of 76.58 and 65.18%, respectively, when the SOFC system is operated at an air-to-fuel ratio of 8, steam-to-fuel ratio of 6, and bio-oil flow rate of 0.0041 mol s⁻¹.     

碎软煤层条带瓦斯地面高效抽采技术研究

为了提高碎软煤层条带瓦斯抽采效率和效果,基于目前地面瓦斯抽采主要采用垂直井或从式井的方式抽采效果差、效率低的现状,通过理论和实验分析论证了穿岩层压裂改造煤储层的可行性,提出了在目标煤层顶板岩层中钻水平井,并通过垂直向下射孔以及采用泵送桥塞分段进行压裂的方式进行地面瓦斯抽采。试验结果表明:顶板分段压裂水平井单井产量高、高稳产期更长、产量衰减更慢;有效水平井段控制区域内瓦斯下降均匀,更有利于进行条带瓦斯抽采;相同投资条件下,采用水平井的方式瓦斯抽采效率和投入产出比更高。